TRU VUE® Reflection Control®
Reflection Control® glass enhances the beauty of artwork with etched matte-like finish that scatters light to minimise unwanted glare.

Technical Info

• Etched matte-like finish to minimise glare and allows 89% light transmission
  
• 2.5mm glass substrate

When To Use

• Ideal for minimising glare and reflection when UV protection is not a concern
  
• Use on any framing project with up to two mats away from artwork without significant resolution loss

Handling

• Glass should be handled with care. To avoid injury cotton gloves should be worn
• Avoid dragging the lites of glass against one another when removing from the box
  
• Do not slide the lite of glass into place. Lift it up to adjust reposition

Cutting

• Place a slip sheet or a non-slip matboard between the glass and the back of the wall cutter
  
• Do not score the UV coated side. The inkjet printing stating "this side faces artwork" indicates the UV coated side
  
• Place the lite of glass in the wall unit with UV coated side toward the wall, facing the slip sheet or matboard
  
• Keep the glass cutter clean of glass chips by brushing away fragments frequently with a horse hair brush

Cleaning
All of Tru Vue glass products are clean and ready to use. If spot cleaning is needed use the following techniques:

• Place the glass on a clean, non-abrasive surface for cleaning
  
• Use a clean, soft, lint-free cloth to clean the glass. Tru Vue recommends using a micro-fibre cloth
  
• Spray a small amount of ammonia-free cleaner onto the cloth. Spraying on the cloth will prevent overspray
  
• Press the cloth against the glass and clean in round, circular motions